Austar Model 16 LED System for RC Cars
1. Product characteristics
-The intelligent operating system makes them applicable to remote control system of most RC HOBBY car, such as FUTABA, KO, SANWA and other remote control systems.
-The LED system is directly controlled by RC transmitter, without needing any auxiliary equipment, to be convenient and reliable.
-The LED system contains 16 LED high simulated car lightings.
-The LED system Lighting effects contain daytime mode, night mode, fog mode and mode all emergency of which can be freely switched.
-The LED system contains 5 modes of flash lights to rich flash effect.
2. Product parameters
3. Product list
-Working voltage: 4.8V- 6.0V ?LED system control box x 1PC
-Working current: 120mA ?LED system group (16PCS), including the following attachments:
-Dimensions: 49 x 32 x 16mm 5mm White LED group x 6PCS
-Length of light connecting line: 30cm 5mm Red LED group x 4PCS
-Length of servo extension wire: 32cm 3mm Yellow LED group x 4PCS
-Weight: 55g 5mm Blue LED group x 2PCS
-Servo extension wire x 2PCS
-One manual
4. Product installation
a) Select car shell for loaded LEDs, and drill holes on appropriate position of the shell;
b) Stick the LED system control box at the appropriate position in car;
c) Insert the LED into the socket of the LED system control box;
d) Insert the LED into the hole of the car shell and fasten it;
e) Insert CH1 and CH2 into one end of extension wire whose other end is connected to corresponding socket of receiver;
f) Connect rudder and throttle servo / electric controllers to sockets of CH1 and CH2;
g) Adjust all connections and avoid interference of receiver antenna and the movement of any car part;
h) Install all the wires, check to ensure proper installation and switch on the power.
5. LED light control
-Please ensure that ST gear on the transmitter is set as NOR and TH gear as REV, then switch on the power of receiver, and then turn on the power of transmitter.
-When the power of LED system control box is switched on, all LED will be on for 1 second,
-When the LED system control box receives control signal, all LED will flash 5 times, during this time period please do not operate the transmitter.
-Set the system to daytime mode, when other modes are needed, CH2 (accelerator of transmitter) and CH1 (direction wheel) should be operated to control, and the steps are as follows:
1) Push CH2 (accelerator) to the braking condition (brake lights will be on) and keep this operation;
2) Stabilize CH1 (rotation direction wheel) 3 times to the left or right to enter LED state;
3) Release the accelerator CH2.
Free Shipping & Return
Free shipping on all orders over Rs. 2000
Money back guarantee
100% original products
Online support
11pm to 8pm
-
- Out of stock
- Out of stock
- Out of stock
- Out of stock
-
Police Car Style Single LED Light (Blue)
Special Price PKR995.00 Regular Price PKR1,010.00 - Out of stock
- Out of stock
-
- Out of stock
- Out of stock
-
G.T. Power 12 LED RC Car Flashing Light System for RC Car 1:10 1:8
Special Price PKR1,545.00 Regular Price PKR1,725.00Out of stock -
G.T. POWER Car Sounds/Light Simulated System
PKR6,495.00Out of stock - Out of stock
- Out of stock
- Out of stock